NETW206 Final Exam Latest 27 August 2014

profileRSaleem
 (Not rated)
 (Not rated)
Chat

Question 3. 3. (TCO 1) _____ control(s) which end devices are allowed to communicate on the network. (Points : 5)

The access layer
Business goals
Collapsed core
Convergence

 

Question 4. 4. (TCO 1) _____ will determine the design requirements for a network. (Points : 5)

Business goals
Personal preference
Location
None of the above

 

Question 5. 5. (TCO 1) Which of the following illustrates properly designed hierarchical networks that achieve near-wire speed among all devices? (Points : 5)

Collapsed core
Convergence
The core layer
Performance

 

Question 6. 6. (TCO 2) Startup configuration is stored in ________. (Points : 5)

ROM
PRAM
NVRAM
Flash

 

Question 7. 7. (TCO 2) The average amount of data that is actually transmitted as opposed to the rating of the port is _____. (Points : 5)

source MAC address
switch fabric
throughput
unicast transmission

 

Question 8. 8. (TCO 2) _____ is a Layer 2 identifier for the frame's originating NIC or interface. (Points : 5)

Propagation delay
Source MAC address
Switch fabric
Throughput

 

Question 9. 9. (TCO 2) _____ is a dedicated connection between two hosts. (Points : 5)

Half-duplex communication
Latency
Microsegment
Multicast transmission

 

Question 10. 10. (TCO 2) A _____ is a frame that is sent from one host and addressed to one specific destination. (Points : 5)

source MAC address
switch fabric
throughput
unicast transmission

 

Question 11. 11. (TCO 3) Extended-range VLANs are identified by a VLAN ID between which of the following ranges? (Points : 5)

1,000-9,000
1,006-4,094
1,006-2,094
1,000-4,094

 

Question 12. 12. (TCO 3) A _____ VLAN is a VLAN that is configured to carry only user-generated traffic. These VLANs are sometimes referred to as user VLANs. (Points : 5)

data
default
native
none of the above

 

Question 13. 13. (TCO 3) Which VLANs are allowed over the link when a new trunk link is configured on an IOS-based switch? (Points : 5)

All defined VLANs are allowed on the trunk by default.
Each VLAN, or VLAN range, that is specified with the switchport mode command
Each VLAN, or VLAN range, that is specified with the vtp domain command
Each VLAN, or VLAN range, that is specified with the VLAN database command

 

Question 14. 14. (TCO 3) Which would not be one of the characteristics of a typical VLAN? (Points : 5)

VLANs logically divide a switch into multiple, independent switches at Layer 2.
Trunk links can carry traffic for multiple VLANs.
VLAN implementation significantly increases traffic due to added trunking information.
A VLAN can span multiple switches.

 

Question 15. 15. (TCO 3) Which of the following configures the port to negotiate a trunk? (Points : 5)

Switchport mode trunk
Switchport mode dynamic desirable
Switchport nonegotiate
Switchport mode access

 

1. (TCO 3) Which of the following best describes the mapping between VLANs and IP subnets in a modern switched network? (Points : 5)

One VLAN to many IP subnets
One IP subnet to one VLAN
One IP subnet to many VLANs
Varies with the model of Cisco Catalyst switch

 

Question 2. 2. (TCO 3) Which of following VLAN frame encapsulation types are configurable on a Cisco switch? (Points : 5)

VTP
802.1Q
LLC
None of the above

 

Question 3. 3. (TCO 4) Which of the following depicts a VTP domain? (Points : 5)

Switches share VLAN information; the boundary is defined by a Layer 3 device.
It can only create, delete, and modify local VLANs.
It advertises VLAN configuration information and can create, delete, and modify VLANs.
It restricts broadcast traffic to those trunks that must be used to reach the destination devices.

 

Question 4. 4. (TCO 4) A _____ stores VLAN information only in RAM. (Points : 5)

VTP client
VTP domain
VTP pruning
VTP server

 

Question 5. 5. (TCO 4) Which VTP mode should a Cisco switch be set to if this switch is to add or delete VLANs to a management domain? (Points : 5)

Transparent
Server
Auto
Client

 

Question 6. 6. (TCO 5) Which of the following is the closest to the root bridge? (Points : 5)

Root port
Spanning Tree Protocol
Spanning-tree algorithm
Switch diameter

 

Question 7. 7. (TCO 5) What is the time spent in the listening and learning states called? (Points : 5)

Forward delay
Forwarding state
Hello time
Learning state

 

Question 8. 8. (TCO 5) The time between each BPDU sent on a port is called which of the following? (Points : 5)

Forwarding state
Hello time
Learning state
Listening state

 

Question 9. 9. (TCO 5) A term for when the port is administratively shut down is _____. (Points : 5)

designated ports
disabled state
forward delay
forwarding state

 

Question 10. 10. (TCO 5) In the _____ state, the MAC address table is built but does forward user data frames. (Points : 5)

forwarding
hello time
learning
listening

 

Question 11. 11. (TCO 5) Which contains a priority value and the MAC address? (Points : 5)

Bridge priority
Bridge protocol data unit
Designated ports
Bridge ID

 

Question 12. 12. (TCO 6) VLAN is a logical group of ports, usually belonging to _____ to control the size of the broadcast domain. (Points : 5)

a single IP subnet
multiple IP subnets
either a single IP subnet or to multiple IP subnets
none of the above

 

Question 13. 13. (TCO 6) Which command is used to determine whether inter-VLAN communication is functioning? (Points : 5)

show vlan
ping
ipconfig
show interface

 

Question 14. 14. (TCO 6) Inter-VLAN routing _____ additional subnet broadcast addresses. (Points : 5)

requires
does not require
sometimes requires
none of the above

 

Question 15. 15. (TCO 6) How many physical interfaces are required to perform inter-VLAN routing with traditional inter-VLAN routing? (Points : 5)

One port per VLAN
Two ports per VLAN
Four ports per VLAN
No physical interface per VLAN

 

 

 

    • 7 years ago
    NET 206 Final Exam Solution
    NOT RATED

    Purchase the answer to view it

    blurred-text
    • attachment
      netw206exex.docx