Circuit Analysis Techniques in Multisim
polalolaCircuit Analysis Techniques in Multisim
This week’s lab is based on the application of circuit analysis techniques to a resistive circuit in Multisim. You will learn to utilize Multisim to perform the mesh analysis.
- Work Exercise 48 from Chapter 4 to determine the current ‘i1’ and power supplied by 1V source.
- Redo the problem, this time without the dependent current source ‘5i1’.
- Fill in the calculated values in the table below:
Calculated current ‘i1’ | Calculated Power supplied by 1V | Measured Current ‘i1’ | Measured Power supplied by 1V | |
With Dependent Source (5i1) | ||||
Without Dependent Source (5i1) |
- Construct Figure 4.73 from Chapter 4 in Multisim.
- Run the simulation to measure the current ‘i1’ and power supplied by 1V source record the measurements in the table. (Use 5% tolerances for each of the resistors)
- Next, remove the dependent source ‘5i1’ from the circuit and run the simulation again to record the measurements in the table. (Use 5% tolerances for each of the resistors)
- Take the screen capture for the measurements of current and power supplied and dissipated by each resistor and complete the table above.
- Answer the following questions:
- Are the measured values same as calculated values? If not, explain why they are different?
- Is the supplied power distributed among all the components in the circuit? Show that total power supplied is equal to the sum of powers dissipated in each component.
- What was the effect of removing the dependent source from the circuit? Does the overall power supplied or power dissipated change?
- Create a new word document called “Lab2_StudentID.docx” with your GID substituted into the file name.
- Save the analysis from step 1 & 2 and simulation results from step 4 along with the table and screen captures of all the measurements. Make sure to answer the questions in step 5.
- Upload file “Lab2_StudentID”.
Grading Rubrics
Demonstrate understanding of Kirchhoff’s and Watts laws | 10 points |
Analyze the circuit in Exercise 48 to calculate Current and Power | 25 points |
Circuit design in Multisim (Figure 4.73) | 10 points |
Measurement of Current and Power in Multisim (With dependent source) | 10 points |
Measurement of Current and Power in Multisim (Without dependent source) | 10 points |
Use of resistor tolerances | 5 points |
Answer to the questions | 20 points |
Lab Report (includes table, measurement with proper units, screenshots, APA guidelines) | 10 points |
Total | 100 points |
- 5 years ago
- 30
Purchase the answer to view it
- lab_depend.docx
Purchase the answer to view it
- circuit_analysis_techniques_in_multisim.zip
- 2 questions in chemistry
- MKTG 410 Week 5 Assignment; Internet Marketing (3 Pages)
- Financial Accounting Homework Help
- bus 544 w1-1
- world Cultures 1 week 5
- BUS 660 Contemporary Issues in Organizational Leadership
- Critical Thinking: Jackson County Judges: MTH410 Module 3
- SAI430 Week 4 iLab
- W4Q
- 1500 word essay of a movie
Need Home Work
NOT RATEDCircuit Analysis Techniques in Multisim
This week’s lab is based on the application of circuit analysis techniques to a resistive circuit in Multisim. You will learn to utilize Multisim to perform the …
4 years ago